Auto Page RF-505 Instruction Manual download pdf (Page 13)

SETTING UP RF COMMUNICATION WITH

YOUR RECEIVER

RXRT505(ONLY)

After you have switched the above receiver on,

the thermostat will automatically pair. When

the red LED stops flashing, the unit has

successfully paired.

If you have difficulty in pairing the thermostat,

we recommend changing the address codes in

the thermostat and the receiver.

To adjust the RF address code of the receiver,

simply push up one or more of the 5 DIP switch

levers on the DIP switch bank located on the

back of the receiver (the levers are numbered 1

to 5 from bottom to top, as shown in the picture

left), and then make a note of the setting of

each switch:

To adjust the RF address code of the thermostat,

remove one or more of the jumper caps located

on the back of the unit (labelled 1,2,3,4 and 5,

and shown in the picture left) so that the

jumper settings match the settings made on the

receiver:

RXVBC605, RXWBC605,RXBC605 & RXST625

To enter pairing mode press and

hold SELECT for 3 sec and the

thermostat will show 10SY (see right)

once the thermostat is in pairing

mode press and hold the sync button

on the receiver (see page 14) wait for

the red LED on receiver to change

state then press any key to cancel

and return to the main screen.

RT505TX INSTRUCTION MANUAL

DIP Switches

Receiver

Jumper Caps

For full instructions on pairing the RXRT505 see page 7 of the receiver manual.

Salus RT505TX Manual 011_89 04/09/2012 08:59 Page 13

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Auto Page RF-505 Instruction Manual Page 13